Add Extra Sections


Icon:
   
   


Introduction

This command allows designers to insert additional chainages/sampling along a selected string, without resampling.

This command is accessible from the menu system, the Vertical Grading Editor window, the Design Data form and the Model Builder form.

Use the command buttons on the left hand side to add chainages to the list on the left hand side - each section added is considered to be of type Extra Sampling.  The same list is available from the Resample Cross Sections Form > Add Extra Sampling button.

Details

Upon selecting the command the following form is displayed:


 

Selections list List of added sections
  Start Chainage Added section at this chainage
  End Chainage Added section at this chainage
  Spacing Regular spacing between start and end chainage for extra sections
  Show in VGE Tick on to display these sections in the VGE

Add Single Chainage

Pick a chainage location from the drawing to add to the list

Sort

Sort the list in increasing chainage order

Delete Selected

Deletes the selected line
Note: the first column of the table shold be selected when running this option
  Insert Range of Chainages These methods add a start and end chainage, as well as setting a regular spacing of chainages between
    Add Every Pick a regular spacing for adding extra chainages/sampling.  Used in conjunction with one of the following add options:
    Pick Start/End Extents Pick two chainage locations from the drawing to add sections between these two chainages.
    Pick Alignment For Extents Pick an alignment from the drawing - it will be used to set the start and end chainage
Zoom/Pan Zoom/Pan in the drawing
Zoom to Range Zoom to chainage extents in highlighted entry
Refresh/Update Table Refresh list and update section sampling on the string

OK

Apply and exit.

Cancel

Exit the form without deleting any data.